CMD Reproduction FD-4000 Floppy Disk Drive for use with Commodore 64, 64c, 128, 128D, 128DCR, Plus 4, C16, C116 Constructed by: ToTs RETRO "COREi64 PCBs/Cases are used under Agreement with COREi64. CMD DOSrom used in the construction of this drive is an officially licensed copy" Featuring a Fully Licensed and Authentic Copy of "FD-4000 Jiffy Dos Rom v1.40" Now available, a 100 percent fully functional FD-4000 reproduction drive that contains a fully licensed DOSrom. CMD FD-4000 Specifications FD-2000 also available Extra-Density 3.5" Floppy Disk Drive (downward compatible with FD-2000 and 1581 diskettes) Amazing 3.2 MB Extra Density Mode plus FD-2000 1.6mb Native compatibility and two 800K Double Density Modes (Native and 1581-compatible) 20% faster than a 1581 on a stock computer and up to 1500% faster on JiffyDOS equipped systems Emulate multiple 1541/71/81 disks for compatibility or use Native Mode partitions for greater flexibility True Subdirectory support in Native partitions DIP-Switch configurable as device number 8 through 15 Front panel SWAP button for instant device 8 or 9 selection Innovative compact design This reproduction FD-4000 disk drive is fully assembled and tested. The case is a visually respectful FDM recreation of the original FD-Series case. The main logic board is a recreation that's been re-drafted and cleaned up. All the chips on the logic board are socketed which will allow for easy service work should it be required some decades from now. The price includes the fully assembled and tested drive, and new 9V 1A switching power supply. You will need to supply your own IEC serial cable and Commodore 64/128/VIC-20 etc computer. Case A 3D printed reproduction of the Creative Micro Designs Inc. These are Printed and Constructed by ToTs RETRO As with all COREi64 design cases, this case comes to you equipped with embedded brass heat sets and screws to not only keep your drive board secure in the case, but also keep the lid tightly mated to the base. This case is presently available in all black PLA. These drives are made to order, so please allow up to 1 week lead time before shipment. Any Questions do not Hesitate to ask