60" Extruded Press-In Track Cover Smooths the floors of transit vehicles Prevents dirt and waste from clogging the L-Track Rolls of 60 inches ( 5 ft., 152.4 cm ) Compatible with L-Track Can be cut-to-length for Shorter L-Track Lengths The covers are designed specifically for use on L-Track sections that are used as anchors to secure mobility devices in transport buses, vans, or other vehicles. The covers are used on sections of L-Tracks that are not in use. The press-in, track cover creates a smooth bridge from one side of the track to the other while making maneuvering much easier as sharp edges and catch-point pockets on the vehicle floor are eliminated. The track cover also prevents dirt and waste from accumulating in the track. The plastic covers come in rolls of 60" or 5 feet and can be easily trimmed with an exacto blade during installation. Stay compliant with the updated ADA accessibility guidelines (ADAAG) for buses and vans. T302 Walking Surfaces T302.1 General. Walking surfaces in non-rail vehicles shall comply with T302. T302.2 Slip Resistant. Walking surfaces shall be slip resistant. T302.3 Openings. Openings in walking surfaces shall not allow the passage of a sphere more than 5/8 inch (16 mm) in diameter. Elongated openings shall be placed so that the long dimension is perpendicular to the dominant direction of travel. T302.4 Surface Discontinuities. Surface discontinuities shall be oe inch (13 mm) high maximum and shall be beveled with a slope not steeper than 1:2. SKU: Q5-7550-T60