Product Introduction 2.8-inch color screen, supporting 16BIT RGB 65K-color display for rich color rendering 320240 resolution, with optional touch function Uses SPI serial bus, requiring only a few IOs to activate the display Equipped with an SD card slot for easy experimental expansion ### Interface Definition 1 VCC: 5V/3.3V power input 2 GND: Ground 3 CS: LCD chip select signal, enabled at low level 4 RESET: LCD reset signal, reset at low level 5 DC/RS: LCD register/data selection signal; low level: register, high level: data 6 SDI(MOSI): SPI bus write data signal 7 SCK: SPI bus clock signal 8 LED: Backlight control, lit at high level; connect to 3.3V for constant on if no control is needed 9 SDO(MISO): SPI bus read data signal; no need to connect if read function is not required (The following are touch screen signal wires; no need to connect if touch function is not required or the module itself does not have touch function) 10 T_CLK: Touch SPI bus clock signal 11 T_CS: Touch screen chip select signal, enabled at low level 12 T_DIN: Touch SPI bus input 13 T_DO: Touch SPI bus output 14 T_IRQ: Touch screen interrupt signal, low level when touch is detected ### Product Specifications Display Color: RGB 65K Color SKU: - With touch: MSP2807 - Without touch: MSP2806 Size: 2.8 (inch) Type: TFT Driver IC: ILI9341 Resolution: 320*240 (Pixel) Module Interface: 4-wire SPI interface Active Display Area (AA Area): 43.2x57.6 (mm) Module PCB Board Size: 50.0x86.0 (mm) Operating Temperature: -20C ~ 60C Storage Temperature: -30C ~ 70C VCC Power Supply Voltage: 3.3V ~ 5V Logic IO Voltage: 3.3V (TTL) Power Consumption: Approximately 90mA Product Weight: 25 (g)