1:200 Scale Plastic Snap-Fit ? Boeing 757-200 ? Length:9.5" Wingspan: 8.5" These models from Flight Miniatures are made of plastic and don't need any glue or paints. The assembly is very basic and takes only a few minutes. Assembly consists of nothing more than attaching the wings to the fuselage and then attaching the tail and elevators. Special care has to be taken while attaching the wings since the fitting in these models is quite tight and some pressure needs to be applied. The pressure needs to be applied on the wings and onto the fuselage. Do not, for example, hold the wings from the engines and apply force like that since this will damage and/or break the engine. A display stand is included. This is not a toy. Recommended for 15 and up. The Boeing 757 is a mid-size, narrow-body twin-engine jet airliner that was designed and built by Boeing Commercial Airplanes. It is the manufacturer's largest single-aisle passenger aircraft and was produced from 1981 to 2004. The twinjet has a two-crew member glass cockpit, turbofan engines of sufficient power to allow takeoffs from relatively short runways and higher altitudes, a conventional tail and, for reduced aerodynamic drag, a supercritical wing design. Intended to replace the smaller three-engine 727 on short and medium routes, the 757 can carry 200 to 295 passengers for a maximum of 3,150 to 4,100 nautical miles (5,830 to 7,590 km), depending on variant. The 757 was designed concurrently with a wide-body twinjet, the 767 and, owing to shared features, pilots can obtain a common type rating that allows them to operate both aircraft.