ONE 5.1"x4.52" inch Die Cut Dabbing Unicorn Sticker. These are sticky on the backside so they will be applied on the OUTSIDE of your car, truck, boat, kayak, SUP, motorcycle, cup, etc... There made to last for 5 to7 years in direct and full sun. These are designed and printed here in our warehouse in Atlanta GA and all orders are shipped directly from us and by us. You are Getting ONE..... with FREE SHIPPING to any USA city. They were printed in our shop on Roland Eco Solvent printers using 3M 3.2mil 5 -7 year Vinyl. This material and then was laminated with a Ultra High Gloss laminate to last 5 to 7 years in FULL - DIRECT Sunlight. FREE shipping to ANYWHERE in the USA.... So buy 1 or 100 and you still get FREE Shipping. Just clean the surface first to ensure that it is free from: grease, dirt, oil, etc... also make sure that the surface is dry. These are sticky on the BACK.... so they will have to be applied on the OUTSIDE of your window, etc... Features This Decal is for funny purposes and based on car culture, Each Car enthusiast designs and dresses up their car differently. This is when JDM Decal Bomb designs comes in action. This helps you design your car an unique way to create your own flavor. Stick This decal anywhere you like or mix this into your current sticker bomb design. This decal can be applied anywhere -Package Included- 1 - Decal Sticker 5.1"x4.52" -How To Apply- Clean area you wish to apply your decal with soap and water, dry area and alcohol preferred decal location for a clean application area. Once dry, simply peal the application tape from the decal backing on an angle slowly. Note: if any part of the decal does not transfer to the application tape simply lay tape back down and place on a hard surface and burnish(rub) the decal with your squeegee or credit card and retry. Once decal is removed from backing carefully place your decal in the desired location. Note: pre plan ahead on angle and exact placement of decal as there are no adjustments using this method. Once it sticks that will be the location of the decal. After placing decal on you desired surface, burnish the transfer tape with your squeegee or credit card to apply and remove any air bubbles. Peel transfer tape back at an angle slowly to expose your new decal. If any part of the decal lifts up in this process, simply lay transfer paper back down and burnish again. Continue to remove until transfer paper is completely removed and your decal is attached to your application surface. Your are now finished and able to enjoy your new decal, wait about 2 days before washing your vehicle. If placed on an indoor surface like a glass bowl, hand wash only as needed